Can anyone tell me where I can find the bullet type terminals used on the wiring for a 1981 GL 1100? The bike started life as an "I", by the time it bacame my project bike it had lost all of its fairings. As a result, the I need to make wire patches to go from the main wiring harness to the now free standing turn signals. The horns are not a problem they use a "spade terminal" which I had no problems finding a match at my local hardware store.
The smallest male/female bullet terminals I have been able to find at my local hardware store or NAPA dealers are (3.99mm) which are larger than those already on the turn signals that came in a box with the bike. I would like to duplicate the existing wire connections as much as possibe.
Technical information and Q&A applicable to all years and models of Goldwings
- Sponsored Links
3 posts • Page 1 of 1
- Posts: 1052
- Joined: Wed Nov 30, 2011 4:17 pm
- Location: Hermansville, Mich
- Motorcycle: 1990 Gold wing Trike
I have found some rare connections at Radio Shack or even computer repair shops.You may have to buy in bulk but not too hard to find.
Proud member Patriot Guard
- Site Admin
- Posts: 17497
- Joined: Fri Oct 03, 2008 4:16 pm
- Location: Strongsville, OH
- Motorcycle: 2000 GL1500 SE
1982 GL1100A Aspencade (sold)
1989 PC800 (wife's!)
1998 XV250 Virago (sold)
2007 Aspen Sentry Trailer
I use digikey.com for most of my electronics, and they will have any type or size of bullet terminal you are looking for.
Who is online
Users browsing this forum: No registered users and 2 guests