Dyna ignition cable does not line up with hole in the cover.


Information and questions on GL1000 Goldwings (1975-1979)
  • Sponsored Links
sfruechte
Posts: 193
Joined: Tue Mar 09, 2010 12:53 pm
Location: La Crosse, WI
Motorcycle: 1977 GL1000

Dyna ignition cable does not line up with hole in the cover.

Postby sfruechte » Wed Oct 10, 2012 3:18 pm



Has anybody had any experience where a new Dyna ignition cable, when timed correctly does not line up with the hole in the points cover? I just installed one and it is a good half in or more off and there is no way it will go through that hole unless I remove the screw holding it to the Dyna ignition plate.

Also, the timing of the second module to get both banks of cylinders firing at even close to the same time has it barely holding on with the little allen screws.

Any ideas?

Thanks.



Return to “GL1000 Information & Questions”




Who is online

Users browsing this forum: No registered users and 1 guest