Transmission blueprint


Information and questions on GL1000 Goldwings (1975-1979)
  • Sponsored Links
doug76020
Posts: 6
Joined: Sun Nov 15, 2009 5:53 am
Location: Azle Texas
Motorcycle: 1979 gl1000

Transmission blueprint

Postby doug76020 » Fri Jul 02, 2010 6:07 am



Anyone know how to get a blueprint (shaft spacing) for a GL1000 Thanks Doug



raycw
Posts: 127
Joined: Wed May 19, 2010 11:02 pm
Location: Jackson, CA
Motorcycle: 88 GL1500

Re: Transmission blueprint

Postby raycw » Fri Jul 02, 2010 12:17 pm

The transmission layout is in the service manual. Is there something particular you need about the spacing??? PM me... I have the manual if you don't.

doug76020
Posts: 6
Joined: Sun Nov 15, 2009 5:53 am
Location: Azle Texas
Motorcycle: 1979 gl1000

Re: Transmission blueprint

Postby doug76020 » Sat Jul 03, 2010 1:27 am

I have the lay out of transmission from manual. What I needed was the exact distance between in put shaft,counter shaft and out put. I'm using the gears from a junk motor to make a two speed splitter gear box for a three wheel Cushman I repowerd with a GL motor. So I have a hi low rear end ( ya I know to much time on my hands ) But it's OK now I'm almost finished with machining. Thanks Doug

raycw
Posts: 127
Joined: Wed May 19, 2010 11:02 pm
Location: Jackson, CA
Motorcycle: 88 GL1500

Re: Transmission blueprint

Postby raycw » Sat Jul 03, 2010 8:35 am

Sounds like a fun job... sorry, I can't help with those measurements.

User avatar
78AzWing
Posts: 126
Joined: Sun Oct 04, 2009 4:50 pm
Location: San Tan Valley, Arizona
Motorcycle: 1978 GL1000 UnDressed and Progressively Weber Carbureted

Re: Transmission blueprint

Postby 78AzWing » Sat Jul 03, 2010 7:55 pm

Pics! Pics! :uwop: :shock:


Meddle not in the affairs of Dragons
For thee are Krunchie and taste goode with Ketchup!


Return to “GL1000 Information & Questions”




Who is online

Users browsing this forum: No registered users and 3 guests