Splitting The crank cases on a GL1000


Information and questions on GL1000 Goldwings (1975-1979)
  • Sponsored Links
Post Reply
User avatar
GL1000-1976-SCX-593P
Posts: 102
Joined: Mon Jun 16, 2014 10:02 am
Location: United Kingdom
Motorcycle: 1976 GL1000 Gold Wing
1976 GL1000 Executive (Replica)

Splitting The crank cases on a GL1000

Post by GL1000-1976-SCX-593P » Sun Feb 25, 2018 1:34 pm



I am in the process of splitting the motor to fit a new Primary chain and a new neutral switch, The motor has been re-painted in the past and may even have been apart before??? (not sure about that bit) but the cases dont seem to want to budge, I was going to fasten one side down to the bench and then Put ratchet straps to the roof of my wooden shed and gradually apply pressure, just wondered if anyone has any better ideas???



User avatar
dingdong
Posts: 3330
Joined: Thu Apr 08, 2010 8:35 am
Location: Oklahoma City
Motorcycle: 1976 gl1000
1993 gl1500
2004 NRX1800 Rune

Re: Splitting The crank cases on a GL1000

Post by dingdong » Sun Feb 25, 2018 1:48 pm

Try threading a couple of the case bolts back in part way at the corners then tap tap tap the bolts with a hammer. Not too big of a hammer though. lol!
Tom

A well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed.

User avatar
virgilmobile
Posts: 8289
Joined: Sun Sep 19, 2010 5:39 pm
Location: Denham Springs,La.
Motorcycle: 1988 GL1500 I
Previously owned
78 GL1000
81 GL1100
82 GL1100 I
83 GL1100 I
83 GL1100 standard
84 GL 1200 I

Re: Splitting The crank cases on a GL1000

Post by virgilmobile » Sun Feb 25, 2018 2:53 pm

They stick pretty tight...Be positive that all the hidden case bolts have been removed.
The case halves are guided in alignment by short steel sleeves..They are the sticking part...

Post Reply