Pulse Generator Problems


Information and questions on GL1100 Goldwings (1980-1983)
  • Sponsored Links
User avatar
echinus1988
Posts: 115
Joined: Fri Jul 19, 2013 7:53 pm
Location: Denver, Colorado
Motorcycle: 1982 GL1100 Aspencade

Pulse Generator Problems

Postby echinus1988 » Mon Nov 18, 2013 12:56 am



Well, I don't normally get frustrated but I am definitely there.

I had a running motorcycle until I replaced the stator. Now I have no spark so I checked and found the pulse generator was not spinning. So I removed the swing arm but cannot get the pulse generator out even though it says I can. Why you might ask, after all, it says in the book, I can just pull it out. It won't pull out, the enclosure jams on the bar behind it, the advance is hooked to the PG frame.

So I can't replace the pin that is probably broken or do much of anything until I figure out how to remove things and replace that pin! I am totally confused and that doesn't happen usually since I can usually figure things out. I have been working on it quite a while now and am making no progress.

I am open to any suggestions because I am not getting anywhere with this bike right now and can't figure out my next step.

Any suggestions? As usual, I appreciate any help I can get here.



User avatar
RhinoWing
Posts: 41
Joined: Wed Oct 10, 2012 6:00 am
Location: Cape Town, South Africa
Motorcycle: 1981 GL1100 InterState

Re: Pulse Generator Problems

Postby RhinoWing » Mon Nov 18, 2013 6:06 am

Hi. I had the same problem that the pulse generator would not budge. Sprayed some penertrating lubricant onto the and a little tap with a small hammer. It slid right off.



Regards
Kevin


Ride like the Wing!!!!!!!


Return to “GL1100 Information & Questions”




Who is online

Users browsing this forum: cowboy450, MaxPointCrawler [Bot] and 1 guest