Rear Master Cylinder 81 1100I


Information and questions on GL1100 Goldwings (1980-1983)
  • Sponsored Links
ldavidpatrick
Posts: 2
Joined: Mon Mar 21, 2011 6:55 pm
Location: jacksonville,fl
Motorcycle: 81 goldwing

Rear Master Cylinder 81 1100I

Postby ldavidpatrick » Sun Apr 17, 2011 10:45 am



Is there a substitute for this since Honda discontinued the part? The one one my bike is all corroded under the boot and wont hold the retaining clip. Any ideas?



User avatar
WingAdmin
Site Admin
Posts: 17050
Joined: Fri Oct 03, 2008 4:16 pm
Location: Strongsville, OH
Motorcycle: 2000 GL1500 SE
1982 GL1100A Aspencade (sold)
1989 PC800 (wife's!)
1998 XV250 Virago (sold)
2007 Aspen Sentry Trailer

Re: Rear Master Cylinder 81 1100I

Postby WingAdmin » Sun Apr 17, 2011 11:44 am

Your best bet is to find a used one in decent condition. There are lots of used parts vendors (check the "Vendors" link at the top of the page), or there's always eBay.

User avatar
littlebeaver
Posts: 4420
Joined: Mon Sep 21, 2009 6:11 pm
Location: Kansas City, Kansas
Motorcycle: 1981 gl 1100 I , 79 Yamaha XS11
Special, 82 Kawa 750 CSR, 82 Kawa 750 LTD, 03 Kawa Nomad 1500, 99 Kawa Voyager 1200

Re: Rear Master Cylinder 81 1100I

Postby littlebeaver » Sun Apr 17, 2011 10:25 pm

I took a dremel wheel to mine, I recut a better groove with a dremel cutting wheel.. Put the clip back in and drilled and tapped three small screws above the circlip to make certain it never pop's loose again... But listen, that's for me.. I don't want anyone getting hurt because of something I wrote just cause it worked for me doesn't mean it will do good for you... Buy another one.. :D

User avatar
littlebeaver
Posts: 4420
Joined: Mon Sep 21, 2009 6:11 pm
Location: Kansas City, Kansas
Motorcycle: 1981 gl 1100 I , 79 Yamaha XS11
Special, 82 Kawa 750 CSR, 82 Kawa 750 LTD, 03 Kawa Nomad 1500, 99 Kawa Voyager 1200

Re: Rear Master Cylinder 81 1100I

Postby littlebeaver » Tue Apr 19, 2011 2:28 pm

If you don't want it anymore I will buy it from you.. :D Send me a pm..

ldavidpatrick
Posts: 2
Joined: Mon Mar 21, 2011 6:55 pm
Location: jacksonville,fl
Motorcycle: 81 goldwing

Re: Rear Master Cylinder 81 1100I

Postby ldavidpatrick » Wed Apr 20, 2011 9:15 pm

I kind of did the same thing I used a drammel tool recut the groove and then heated up the clip so I could make it bigger. Put it back together and it has worked so far.




Return to “GL1100 Information & Questions”




Who is online

Users browsing this forum: MSNbot Media [Bot] and 2 guests