Information and questions on GL1100 Goldwings (1980-1983)
- Sponsored Links
2 posts • Page 1 of 1
I have a 1982 GL1100i just bought as a project. Previously sitting for 3 years and as I was removing the stuck fuel lines I broke this part. To my surprise I've only found the assembly looks to cost about $60.00. All I need is this part any tips on locating or fabricating one out of plastic, or metal?
Ok I've been on and off on my GL1100 project. Shortly after posting I fabricated this piece out of some glued together plexiglass. Lets just say that was my prototype. Went to TAP plastics bought a small solid piece of plastic and shaped it with my Dremel. Its not perfect but it should do the job.
Who is online
Users browsing this forum: No registered users and 4 guests