87 gl 1200i finial drive instalation


Information and questions on GL1200 Goldwings (1984-1987)
  • Sponsored Links
ronscycle1.
Posts: 30
Joined: Thu Aug 29, 2013 11:48 pm
Location: kinmundy ,IL.
Motorcycle: 1987 gl 1200 i

87 gl 1200i finial drive instalation

Postby ronscycle1. » Sun Oct 13, 2013 8:38 pm



can i just slide the axle though the swnig arm without putting on rear wheel to align the finial drive to swing arm ?



86GL1200Rider
Posts: 1
Joined: Wed Oct 09, 2013 10:02 am
Location: Wisconsin Rapids, Wisconsin
Motorcycle: 1986 GL1200 Interstate

Re: 87 gl 1200i finial drive instalation

Postby 86GL1200Rider » Wed Oct 16, 2013 8:27 am

I'm no expert at all in this so I will defer to ANYONE with more experience. I just completed lubing the final drive and I did install the part of the drive shaft inside the swing arm first into the U-joint then installed the final drive unit on the wheel and slid into place...it took forever to get the drive shaft arm back into the U-joint but I found that was the easiest way to do it. Not sure if this is exactly what you were asking but figured i would add my two cents....AGAIN NOT AN EXPERT AT ALL!!!


Return to “GL1200 Information & Questions”




Who is online

Users browsing this forum: julimike54 and 2 guests