Information and questions on GL1200 Goldwings (1984-1987)
- Sponsored Links
3 posts • Page 1 of 1
Hello. Here is problem with my GL1200 - main and rod bearings are died. Who know the standard dimensions of the crankshaft journals? My dimensions now is: main 51,98 mm, rod 42,99. Connecting rods and crankshaft are marked 2F. Can i install the bearings C (brown)? Other colour types is obsolete and out of stock. Maybe i can install some automobile bearings, had anybody expirience like this?
- Site Admin
- Posts: 17188
- Joined: Fri Oct 03, 2008 4:16 pm
- Location: Strongsville, OH
- Motorcycle: 2000 GL1500 SE
1982 GL1100A Aspencade (sold)
1989 PC800 (wife's!)
1998 XV250 Virago (sold)
2007 Aspen Sentry Trailer
The bearings are matched to the crank and block based on measurements taken at the factory during manufacturing. To run properly, they really need to be replaced with the same types - which is hard to do when they aren't available anymore. I highly doubt you'll find automotive bearings that fit and are of the correct dimensions.
WingAdmin wrote:The bearings are matched to the crank and block based on measurements taken at the factory during manufacturing. To run properly, they really need to be replaced with the same types
Ok. What colour type of bearings i have to find? Marks on the rods and crankshaft is 2F, there are no types for it in the manual. Maybe i use something wrong.
Who is online
Users browsing this forum: No registered users and 19 guests