I have been having problems with my fuel injection for several months now.
It would run fine then would not start. I would have to remove the seat and reset the wires, grn/brn and the large bundle as well.
This has worked a few times.
Yesterday I went out and no fuel pump.
Pulled it all apart, and I show no lights on at the ecu.
Checked my relays, all seem ok, just no energize of the fuel pump. I jumped 12 volt to the pump and it works there so I am at a loss
as to what is wrong . Any and all help would be greatly appreciated.
Information and questions on GL1200 Goldwings (1984-1987)
- Sponsored Links
2 posts • Page 1 of 1
My sei had the same problem. I traced it to a bad wire or connection under seat . To fix I spliced a wire between main fuse box harness under tank shelter back to big plug under seat. I damaged the plug under seat after trying to improve the connection. All this was done after confirming that all switches including bank angle sensor was working properly as there are a lot things that need to be working properly to make pump run. My ground wire to pump was good so I only had to run positive wire. Hope this helps. Evan
Who is online
Users browsing this forum: geraldm, Google Adsense [Bot] and 2 guests