starting problem
-
- Sponsored Links
-
- Posts: 2
- Joined: Mon Jun 25, 2012 9:23 pm
- Location: Knoxville, Tennessee
- Motorcycle: 1998 1500 se
- WingAdmin
- Site Admin
- Posts: 18736
- Joined: Fri Oct 03, 2008 4:16 pm
- Location: Strongsville, OH
- Motorcycle: 2000 GL1500 SE
1982 GL1100A Aspencade (sold)
1989 PC800 (wife's!)
1998 XV250 Virago (sold)
2007 Aspen Sentry Trailer
Re: starting problem
Which clutch switch did you check? There are two.
From the ETM:
From the ETM:
Test C1 reads:Symptom: Starter operates in neutral, but not in gear with clutch lever depressed and side stand switch UP.
Diagnosis: Open circuit or faulty reverse diode assembly, clutch switch, or side stand switch; do test C1.
TEST C1: Clutch Switch Isolation
1. Disconnect C326 (clutch switch connector). With side stand switch Up, check continuity of GRN/WHT circuit to ground.
If yes, go to step 2.
If no, check GRN/WHT circuit, side stand switch, and GRN circuit at C28 for an open.
2. Disconnect C325 (clutch switch connector). Check continuity across clutch switch with clutch lever depressed.
If yes, check GRN/RED circuit for an open. If OK, replace reverse diode assembly.
If no, replace clutch switch.
-
- Posts: 2
- Joined: Mon Jun 25, 2012 9:23 pm
- Location: Knoxville, Tennessee
- Motorcycle: 1998 1500 se
Re: starting problem
also forgot to mention the cruise light comes on but the second cruise light does not come on and cruise wont work,does this have anything to do with the not starting problem
- Sempai
- Posts: 303
- Joined: Wed Mar 10, 2010 12:30 am
- Location: Wichita, KS
- Motorcycle: '94 GL1500SE
- Contact:
Re: starting problem
Get out on the road, above 35mph, push your clutch lever forward until it bottoms out, hold it there with your fingers. Try activating the cruise control. If it activates, you may want to check out this thread:serviceman1143 wrote:also forgot to mention the cruise light comes on but the second cruise light does not come on and cruise wont work,does this have anything to do with the not starting problem
http://www.goldwingdocs.com/forum/viewt ... =6&t=12019
Keep the rubber side down.