Dash Light bulbs


Information and questions on GL1500 Goldwings (1988-2000)
  • Sponsored Links
User avatar
wilsonoo
Posts: 19
Joined: Sat Jun 16, 2012 5:48 pm
Location: idaho falls, idaho
Motorcycle: 1990 Goldwing SE

Dash Light bulbs

Postby wilsonoo » Sat Jul 14, 2012 11:48 am



I have a dash light bulb out, the OD and would like to replace it and maybe the speakers. Is there any instructions on this forum or any were. I found some but they seem to be in Spanish............thanks


!990 Goldwing SE, 94000, California Sidecar Trike.

charliektm400exc
Posts: 79
Joined: Wed Dec 23, 2009 4:34 am
Location: Tasmania Australia
Motorcycle: 1996 GL1500SE

Re: Dash Light bulbs

Postby charliektm400exc » Sat Jul 14, 2012 4:46 pm

Look in the How To DIY section. There's a really good post about replacing dash lights with LED's that will have the information you need.

User avatar
wilsonoo
Posts: 19
Joined: Sat Jun 16, 2012 5:48 pm
Location: idaho falls, idaho
Motorcycle: 1990 Goldwing SE

Re: Dash Light bulbs

Postby wilsonoo » Sat Jul 14, 2012 5:48 pm

That looks good, they don't make it easy...........thanks :D
!990 Goldwing SE, 94000, California Sidecar Trike.

User avatar
Sempai
Posts: 295
Joined: Wed Mar 10, 2010 12:30 am
Location: Wichita, KS
Motorcycle: '94 GL1500SE
Contact:

Re: Dash Light bulbs

Postby Sempai » Sat Jul 14, 2012 6:55 pm

1. remove trim from mirror mounts, remove 3 screws that hold each mirror on, remove windscreen adjust locking levers, loosen big philips screw holding the flat spring on and rotate springs to where they are not on top of the dash piece.
2. remove both philips screws holding the grill, and the chrome windscreen trim in place, remove these items.
3. remove the 5 philips screws holding the windscreen in place.
4. remove the philips screws (1 each) holding the headlight adjust and hot air flap knobs, remove knobs, remove the 22mm plastic nuts and both washers from both sides.
5. using a couple of offset picks, release the snaps holding the vents in place under the speakers and remove the vents.
6. using the same picks, pry up the plastic dash to clear the mounting studs that are right where the mirrors had been bolted in place.
7. the speakers are now in the open.
8. reverse instructions to reinstall.


Keep the rubber side down.


Return to “GL1500 Information & Questions”




Who is online

Users browsing this forum: 04 Spirit, Big Blue UK, MSNbot Media [Bot] and 2 guests