I tried searching forums for an answer but didn't see one,
1994 gl1500 Aspencade, I just purchased the bike a week ago and the gentlemen had said it just stopped working one day.
The cruise light comes on when you turn it on , and the when you set it, It shows that it is set. But it don't set. Both lights are on but not working.
He had told me before I purchased the bike that he had timing belts replaced and the carbs done last year. not sure if that would matter ?
My question is what could be wrong ? is it like an old car that's got a vacumn pod, or is it all electronic ? if it does have a vacumn pod where is it ?
Any help deeply appreciated.
cruise sets but dont work
-
- Sponsored Links
- WingAdmin
- Site Admin
- Posts: 18740
- Joined: Fri Oct 03, 2008 4:16 pm
- Location: Strongsville, OH
- Motorcycle: 2000 GL1500 SE
1982 GL1100A Aspencade (sold)
1989 PC800 (wife's!)
1998 XV250 Virago (sold)
2007 Aspen Sentry Trailer
Re: cruise sets but dont work
It is vacuum powered, just like a car. I can't find a picture of the vacuum reservoir installed, but it looks like this:smitty716 wrote:I tried searching forums for an answer but didn't see one,
1994 gl1500 Aspencade, I just purchased the bike a week ago and the gentlemen had said it just stopped working one day.
The cruise light comes on when you turn it on , and the when you set it, It shows that it is set. But it don't set. Both lights are on but not working.
He had told me before I purchased the bike that he had timing belts replaced and the carbs done last year. not sure if that would matter ?
My question is what could be wrong ? is it like an old car that's got a vacumn pod, or is it all electronic ? if it does have a vacumn pod where is it ?
Any help deeply appreciated.
It is located behind the left fairing lower, right along the frame downtube.
The actuator can be seen if you remove the left side engine covers:
-
- Posts: 6
- Joined: Mon Mar 21, 2016 5:19 pm
- Location: pine bluff Arkansas
- Motorcycle: 1994 Goldwing Aspencade
Re: cruise sets but dont work
Thanks for the help I'll get out and check it in the morning.