Spare power connections in fuse box


Information and questions on GL1500 Goldwings (1988-2000)
  • Sponsored Links
Post Reply
Gdgiò
Posts: 30
Joined: Tue Sep 30, 2014 9:17 am
Location: Milan Italy
Motorcycle: Yamaha dragstar Classic (sold)
HD883
Goldwing SE 1999

Spare power connections in fuse box

Post by Gdgiò » Tue Nov 14, 2017 5:29 pm



hello again

i am going to add winter hot grips on my bike so i am looking to the right place to connect an additional fused relay .
I found these screws marked + and - (red circled in the pic) so they shall be available for the purpose . Does anybody know max load applicable to these terminals?
are these terminals already fused? and are those terminals under main power (start key ) ?... I can check of course ....but... thanks






User avatar
chrisz
Posts: 97
Joined: Thu Jun 18, 2015 8:19 pm
Location: Cambridge Ontario
Motorcycle: Honda GL1100 year 1983
Triumph Tiger 1050 year 2008

Re: Spare power connections in fuse box

Post by chrisz » Tue Nov 14, 2017 5:52 pm

Per the owner's manual for a GL1100: Maximum is 60W (5 Amps) (12V). Not sure about your bikes potential.

gwjturner
Posts: 6
Joined: Mon Sep 04, 2017 4:16 pm
Location: Illinois
Motorcycle: 2000 GL1500 SE

Re: Spare power connections in fuse box

Post by gwjturner » Tue Nov 14, 2017 6:27 pm

Those two screws (+/-) are controlled by the ignition switch and are fused at the very top fuse position at 5 amps max.

User avatar
Mh434
Posts: 1172
Joined: Tue Mar 25, 2014 10:24 pm
Location: Victoria, British Columbia, Canada
Motorcycle: 1997 gl1500 SE
Previous:
1981 GL1100I
1989 Kawasaki Concours

Re: Spare power connections in fuse box

Post by Mh434 » Wed Nov 15, 2017 3:15 pm

If you use one of the fuses to send a switched-12V signal to a relay, which in turn is powered from the battery, it will work fine without drawing virtually any power from the accessory circuit. Some heated grips instructions (like the ones that came with my ShowChrome grips) tell you to run the grips power directly from the accessory circuit without a relay.

Do NOT do that - there's simply not enough current to run both the grips & controller properly, even with a high-powered alternator. With a relay, taking its main power from the battery, it will work great.

User avatar
WingAdmin
Site Admin
Posts: 18226
Joined: Fri Oct 03, 2008 4:16 pm
Location: Strongsville, OH
Motorcycle: 2000 GL1500 SE
1982 GL1100A Aspencade (sold)
1989 PC800 (wife's!)
1998 XV250 Virago (sold)
2007 Aspen Sentry Trailer

Re: Spare power connections in fuse box

Post by WingAdmin » Wed Nov 15, 2017 8:33 pm

Or you could use one of the aftermarket power panels, like this one, which I have in my GL1500 and works great: viewtopic.php?f=18&t=10890



Post Reply