Information and questions on GL1800 Goldwings (2001-Present)
- Sponsored Links
7 posts • Page 1 of 1
- Posts: 1865
- Joined: Tue Oct 20, 2009 11:21 am
- Location: Plano, TX
- Motorcycle: 2004 GL1800, 2005 Honda Shadow 750, 2008 Yamaha R6 with RG500 engine, CRF450X, CRF230, CRF250X, XR200, CR500
As standard the 1800 doesn't have a belly pan, it's just got some plastic trim running around the sides (around the exhaust headers). If you have a belly pan, it has to be an after market item and they usually mount with 4 screws (usually screws that pass the rough the plastic side trims and into the belly pan. If you post a picture we can tell you who made the belly pan and give you more exact instructions on how to remove it.
- Posts: 13
- Joined: Sat Jan 01, 2011 12:05 pm
- Location: covington,Louisana
- Motorcycle: 1999 Valkyrie Interstate
2006 GL 1800
2008 GL 1800 Level 3
2008 GL 1800 Airbag
Your belly pan is a after market add on. it is attached using the four lower acorn nuts that hold the bottom side panels. Take off the nuts. Pull the side panels off the studs and then the belly pan off the stud. do the same for the other side. Just reverse the proceedure to put it all back together.
- Steve F
- Posts: 400
- Joined: Thu Apr 07, 2011 8:25 pm
- Location: suburban Chicago
- Motorcycle: 1976 Honda CB750F Cafe' (sold :>( )
Not all belly pans are (I guess) the same, since mine has two d'zus fasteners. Was on the bike when I bought it
"To ride is the reason, the destination the excuse."
Steve F wrote:Not all belly pans are (I guess) the same, since mine has two d'zus fasteners. Was on the bike when I bought it
Mine too. It is a Tulsa brand, and only the forward section has to be removed for oil and filter changes.
However, to remove it entirely, you only need to loosen the 4 acorn nuts......and wear gloves......those edges are sharp!
Who is online
Users browsing this forum: No registered users and 2 guests