WHERE DOES THIS PIECE GO

OTTERCOMET · Post by **OTTERCOMET** » Mon Apr 16, 2018 2:03 pm

I am doing a caliper rebuild on an 82 GL1100I. Completed the rebuild of the right front caliper and was replacing the boot on the mounting bracket, where the pivot pin goes, and this piece fell to the floor - I didn't see where it came from. I removed the left front caliper assembly and I don't see anything similar. The exploded diagram in the Honda factory manual shows something that looks like the piece but is non-specific as to where it goes.
If you know what it is and where it goes, please let me know.

DaveO430 · Post by **DaveO430** » Mon Apr 16, 2018 7:21 pm

It goes on the little ledge on the front (top) of the bracket, The slot goes down over the rotor, the ends of the brake pads sit against it.

Wilcoy02 · Post by **Wilcoy02** » Mon Apr 16, 2018 9:37 pm

should have one on both sides.

RBGERSON · Post by **RBGERSON** » Tue Apr 17, 2018 7:41 am

look here

http://shop.westernhonda.com/fiche_sect ... veh=132952

OTTERCOMET · Post by **OTTERCOMET** » Tue Apr 17, 2018 1:50 pm

Thanks for the input. Got the little piece back where it belongs.
Having access to GoldwingDocs and all the knowledgeable folks who are active on the site has been a great help - and I am likely not finished asking for help as I proceed with this project.

Wilcoy02 · Post by **Wilcoy02** » Tue Apr 17, 2018 2:55 pm

Ask away. Pick our brains at times.

WHERE DOES THIS PIECE GO

WHERE DOES THIS PIECE GO

Re: WHERE DOES THIS PIECE GO

Re: WHERE DOES THIS PIECE GO

Re: WHERE DOES THIS PIECE GO

Re: WHERE DOES THIS PIECE GO

Re: WHERE DOES THIS PIECE GO