Anyone heading to Port Dover on Friday? I will be making the 2 hour trek, arriving around noon. Not sure what to expect as its my first time going, even though Ive been driving a motorcycle for over 34 years.

Just thought I would post this for you guys getting ready to do this and are going to change your seal too. I could not get the shift shaft off. It was hitting on the frame. I read all kinds of major work that you had to do just to get the shaft off. While others came right out. But not mine. Maybe...

I just finalized the install of the shifter brace, difficult journey. I also replaced the shifter shaft seal at the same time so I had to remove the offset shaft. Re-installing it, I played with the position as when I aligned the opening with the dot on the shaft it ended up being to high coming out...

Called the local Honda dealer, I will have a new one in a week for 85 Canadian dollars.

Thanks everyone for your replies and help.

Rambozo wrote: ↑Wed Apr 20, 2022 11:05 am Part number 24710-MT2-000
https://www.partzilla.com/product/honda ... 6ef4578c39

Thanks for the link.

I'm trying to find a similar site in Canada where the shipping isn't $20 USD.

I was finishing up installing the shifter brace on my '96 GL1500, after installing (with new shifter seal) it would not shift up except into neutral. I started taking it back apart to see if there was some interference I did not see before and as I was trying to open up the pinch opening to get the ...

I looks like your contact points are bent. I thought at first they were welded but the video doesn't point to that. Try bending them down when they are in the de-energized position.

New Update.... I have now installed the unit, following the advice given in https://goldwingdocs.com/forum/viewtopic.php?f=14&t=5316. Great amount of information in there. I now have blue tooth connectivity to my radio!!! I originally disconnected both connector 106 and 107 but didn't get any so...

Update... unit came in today. Tested it out, uninstalled cause from China. Seems to work fine. Hope to get it installed Sunday. Will update when job is done!

I pulled the trigger and ordered it. It says it won't be delivered till October so it will be a winter project by the looks of it. I plan on putting it into Aux power, might just splice off the power going to the radio already.

Looking at upgrading/doing something to my radio and with the trend of new phones to not include a headphone jack I have been up in the air of what to do. Especially as I will be upgrading my phone sooner than later. 1) Leave it as is, use my phone and bluetooth headphones 2) Add in the wired aux ca...

Welcome aboard and enjoy our world of wings. It sounds like you have some great plans for your bike. Do yourself a headache reducing favor and be sure to check out the status of your timing belts. If they have been changed, great. If not they are an important item to consider. The recommended 100k ...

Hi everyone! I just purchased my '94 Goldwing Aspencade just the other week with 77K miles, its a U.S. bike but I have it up here in Canada. I unfortunately really started reading up on GoldwingDocs AFTER I bought it just to find out I have the bent transmission fork issue. I plan on purchasing the ...

Thanks for the reply. Once I get it home Ill figure out the size, but was hoping to be able to take one with me when I pick it up.

I just bought my new to me '94 Aspencade. I do need to replace the hinge pin on one of the fold down antenna due to it comeing apart and he could not find the it. What size is the pin and could it be replaced with a spring pin? If so what size?

Thanks in advance.