CAN ANY ONE TELL ME IF I HAVE TO REMOVE THE INLET MANIFOLD IN ORDER TO CHANGE THE PIPES AROUND THE THERMOSTAT, INCLUDING THE BLACK PLASTIC T PIECE 90 DEGREES,
WHATS THE BEST WAY TO DO IT
WATER PIPE LAY OUT/..... diagram???


thanks for reading
brian

1986 GL 1200A !!
AT SEA LEVEL RPM IS 980 AT 600 METERS ABOVE SEA LEVEL DROPS DOWN TO 580 RPM ANY IDEAS WHAT TO DO?
THANKS
BRIAN

My brother in law who lives in st Louis has just bought his first goldy a 87 gl1000 in great mint condition , can any of you recommend a honest person to maintain this bike . and also check if the timing belts were changed ?
THANKS FOR READING THIS
BRIAN

hi guys, can any one recommend a one stop supplier for 85 gl 1200 ltd? i need to buy a stator, clutch disks,chrome gas filter, starter repair kit,rear engine gasket,exhaust gasket (rings).gear lever oil seal,and a few more items . if i buy them on e bay and have shipped to me in Israel the shipping ...

These are the pictures of the burnt wires that I previously sent a topic about.
Any help will be appreciated. Have any of you guys seen this happen before?
Looking to buy parts to repair and possible cause of damage.

Thanks,
Brian

have a friend with a 08 gl 1800 that corrosion has caused a complete burn out of the right side bottom harness on the fuse box....any one maybe can help out to find a harness and fuse box ,
thanks
BRIAN

any ideas where i can buy 2 intake valves p\n 14711-mg9-000 for a 84 gl1200 used ones also O.K. cant find on the bay !!!

spring and cap off, just read wing mans instruction recommends,, filling tube before fitting , its 24.00hours here i will get some sleep and try again to-morrow
thanks for taking the time to answer me Brian

changed the front fork oil seals on a 85 1200 ltd all went well until we tried ti fill the shock with oil!!!!the oil wont go in ????just a few cc go in and that it ,,,,,,,,,,,,,,HELP,,,,,,,,,,,,,,,,,,,,,where did we go wrong
BRIAN

hi guys, the bike in question is a 85 gl1200 ltd and the problem being, that when i removed the air suspension air dryer from the fairing , i found that there was a 2 green wire connector that was disconnected , cant find to what this connector is connected to??? any ideas thanks for reading this to...

looking to buy a rectifier for a 85 ltd .... voltage changes from 9... to.... 11 to ...14 volts while ridding ..new battery discharged after 2 hour ride!! any one had experience with a ricks motor sport rectifier?? $ 108 is it worth it would appreciate if any one can recommenced what rectifier to bu...

wing-man saves the day...............were on our way again.............solenoid to switch red wire no continuity... spliced,,,, and new wire fitted we are back in the seat

thanks

brian

THANKS .. WILL CHECK AS YOU SUGGESTED TO-MORROW MORNING ITS 20.30 HERE AND THE BIKE IS 20 KILOMETERS FROM HERE

this is what happened!!! the bike in question is a 85 gl1200ltd...the problem is ...bike started and ran for approx 1 minute..... ....dead!!! no lights... no horn,,,,, no start .. no dash light battery is fully charged ...when shorting out on the solenoid the starter turns ,,all fuses are good...mai...

hi there all,
85 gl1200 ltd!!

when pumping up the front forks ....the pump works BUT the air pressure does not increase or di crease on the gauge !!any ideas

HI.
THIS IS NOT A POLITICAL CORRECT QUESTION but CAN ANY ONE RECOMEND ME A GOOD WORK SHOP IN I.L. ?? THINKING OF ADDING A SUZUKI 1100GLK TO MY COLLECTION , FOUND A BIKE IN I.L. NEEDS CARB WORK PLUS A GENERAL ONCE OVER BEFORE I IMPORT IT TO ISRAEL
THANKS
BRIAN

had a hip replacement and some alignment done to the pelvis area , to day i tried to get back on one of the 3 bikes i have 85 g1200ltd ,86 Suzuki cavalcade , and a 84 Yamaha venture not feeling to safe to be back on the monsters of the 80"s . thinking of coming down in size and weight of another bik...

looking for O.E.M. or a recommended after market chrome(the owner wants only a chrome pump) thats what is on the bike now, any ideas???

OPPS SORRY VIRGIL spelt your name wrong

problem solved thanks to Virgi :
new OEM r\r waited 2 weeks for it to come from the us (worth the wait)
thanks again to all
BRIAN

ebay>>>>>>>>>>>>>>>

ANY ONE KNOW WHERE I CAN BUY A CHROME FUEL PUMP FOR A 85 GL1200 A??

another bike with a different problem!!!!!!!!!!the bike in question is an 85 1200 a (carbs) when ridding at a steady cruse speed 130 kpm the bike will slow down to 110 kph with out changing throttle position . then have to open throttle untill 130 kph ,,,,back it goes to 110

any ideas ??????????

hey there Virgil. have ordered a original r\r
will keep you informed
BRIAN
i have something that you may find interesting ...send me your e mail address

i will try the one from my Yamaha venture.