Stator help needed

[Oldnautique]

i cut the stator wires and tested voltage between the 3 legs. a-b b-c c-a
im getting about 64v, 64v and 40v.
I believe they should all have the same voltage with very little variation. Can someone confirm ?

By the way the Ohm reading is 1ohm each leg. no continuity to ground.

[AZgl1800]

yup,

that stator is toast. all 3 legs need to be within 5-10 percent, preferably less than 5%

either have it rewound at a local starter/alternator shop ( cheapest and best )
or get a new OEM stator.

the aftermarket ones seem a bit iffy

[Oldnautique]

Thanks. That’s what I thought
Problem is that is a new one I got from Randakks.
They sold me a defective one and said my test is not accurate. They refused exchange or refund. Stated that’s their policy in stators and regulators.

[AZgl1800]

not a good recommendation for Randakks then

[WingAdmin]

not a good recommendation for Randakks then

Randakk's is not the same company it once was before the acquisition in 2016.

[newday777]

not a good recommendation for Randakks then

Randakk's is not the same company it once was before the acquisition in 2016.

Very true

[winguyjo]

don't know what they were like prior to 2016, but i bought a kit from them early 2020 and sent them a question after i recieved it.
still waiting for an answer.