Head's Up™ Voltage Monitor -- who has used one?

[FluffyDog6]

Who has installed one of these Heads Up voltage monitor LEDs on a Goldwing 1500?

https://www.signaldynamics.com/01050

Where did you tap into for the voltage?

How long did it last?

Thanks.

[Rednaxs60]

I had one on my 2012 V-Strom, sold, that I took off and may have lying around. It works quite well, but I prefer a readout - analogue or digital. I put a digital voltage meter on my 1500 - since sold, but had it wired into a relay activated accessory fuse block. Used the Fuzeblock FZ1 because of space limitations.

[joecoolsuncle]

https://www.amazon.com/Transparent-Wate ... B07QKQX4XX

this is what i installed. its cheapanese but totally encapsulated in plastic and so far has been waterproof. give it a quick glance and tell if you are charging by the green band is glowing. i connect to the accessory connection on the fuse block.

stylish, yet functional.

[dingdong]

Mine failed after 2 months. It was intermittent from day one. It was a monthly contest prize.

[WingAdmin]

Who has installed one of these Heads Up voltage monitor LEDs on a Goldwing 1500?

https://www.signaldynamics.com/01050

Where did you tap into for the voltage?

How long did it last?

Thanks.

I've had one on my GL1500 for over ten years, still works fine. It's connected to an accessory line that I ran up into the fairing to power a few different things, so it turns on and off with the bike.

[Gnarly]

Have used one on my last 3 bikes, starting 9 years ago.
Zero issues.
If only ALL factory-omitted essential indicators were this simple!

All are powered by ‘ignition-On’ wiring in each fairing.

Also running one on a ‘57 Allis-Chalmers.

[Pam]

Plan on putting one on my bike this spring. The plan is to hook it into the keyed acc.

[in2it]

This is what I used... I installed it in the far right blank space in the instrustment panel ... there a link in the "How to" section to install the light https://www.improvingclassicmotorcycles ... oducts.htm