Picture of my styrofoam bolt, pin, and screw boards.
This one is marked up for easier viewing.
Not 100% comprehensive but getting pretty close.
Using the parts diagrams to determine which goes where. There is a lot more going on than just "short and long bolts"
Some of the "long bolts" are very similar in length - 5x 14 and 5 x 15 but are different. I'm choosing not to mix them.
Bike seems to be happier when the right size and type of fastener is the proper place
Organism Rectangle Font Art Line
How can you make your own?
1" x 12" x 28" Foam Boards (need two)
Got them at Michael's the craft store.
I
There are two foam boards shown in the picture.
Print the picture diagram on four sheets of 11 x 17 paper - takes two sheets of paper for each board,
Key thing to do: Scale the width (12" side) of the diagram to max out the 11" side of the paper.
Tape the sheets down to the foam boards.
