Page 1 of 1

Clutch adjust cover Gasket / O ring

Posted: Sun Jan 06, 2019 12:57 pm
by Deacon Blues
I’m working on a 1977 Gl1000. The square O-ring under the clutch adjust cover came out in several pieces. I can’t find a part number for this anywhere. Can anyone help with this ? Is an O-ring suitable? Any help would be appreciated.
Thanks

Re: Clutch adjust cover Gasket / O ring

Posted: Mon Jan 07, 2019 9:27 pm
by DaveO430
I see what you mean, the o-ring doesn't seem to be in the parts catalog, at least not where you would expect. An o-ring of the same approximate size should do fine, it doesn't have to hold oil in just keep dirt and water out.

Re: Clutch adjust cover Gasket / O ring

Posted: Sat Feb 09, 2019 6:06 pm
by cfairweather
I designed one and printed it with my 3D printer. I used a TPU filament and it worked just like the original.

Re: Clutch adjust cover Gasket / O ring

Posted: Sun Feb 10, 2019 9:55 pm
by SnoBrdr
Deacon Blues wrote:
Sun Jan 06, 2019 12:57 pm
I’m working on a 1977 Gl1000. The square O-ring under the clutch adjust cover came out in several pieces. I can’t find a part number for this anywhere. Can anyone help with this ? Is an O-ring suitable? Any help would be appreciated.
Thanks
Is it in here: https://www.partzilla.com/catalog/honda ... -rear-case

Re: Clutch adjust cover Gasket / O ring

Posted: Sun Feb 10, 2019 10:39 pm
by cfairweather
That Partzilla link doesn't have the gasket he needs. The one he needs is a "square O-Ring" that seals the clutch adjustment cover. I couldn't find one last week when I needed one, so I made my own using a 3D printer. I will make him one if he send me his address.

Re: Clutch adjust cover Gasket / O ring

Posted: Mon Feb 11, 2019 7:17 am
by SnoBrdr
cfairweather wrote:
Sun Feb 10, 2019 10:39 pm
That Partzilla link doesn't have the gasket he needs. The one he needs is a "square O-Ring" that seals the clutch adjustment cover. I couldn't find one last week when I needed one, so I made my own using a 3D printer. I will make him one if he send me his address.
Yes, I couldn't see one there either.

Re: Clutch adjust cover Gasket / O ring

Posted: Sun Mar 10, 2019 4:42 pm
by Old Fogey
That square O ring was never offered as a spare part. It came glued to the clutch adjustment cover.
Buy some 2mm rubber sheet off eBay and cut yourself one.