Page 1 of 1

front brake stop switch

Posted: Mon Aug 11, 2014 12:46 pm
by squirrel
so changed clutch+brake levers both are exactly the same size as old ones. ( at least i thought they were ) problem is the front brake lever just misses the micro switch to operate the brake light . already disposed of old ones. any ideas welcome

Re: front brake stop switch

Posted: Tue Aug 19, 2014 12:44 pm
by WingAdmin
I'd sand the paint off the area on your new levers, then glop a blob of J-B Weld epoxy in place. Wait for it to cure, then file it down to the proper shape and position needed to actuate the switch. Lastly, a quick shot of spray paint to make it all look nice.