Compatible rear master cylinder push rods

PuppyWing · Post by **PuppyWing** » Sun Mar 04, 2018 11:55 pm

Hi everyone. The rear master cylinder push rods on my 83 Aspencade is pitted and I'm not sure how bad the pitting has to be before it becomes a hazard. But just to be safe I'm interested in getting a new one. I've seen some on eBay for other Hondas that look like they will work but Im not having any luck finding one for the gl1100. Any suggestions?

DaveO430 · Post by **DaveO430** » Mon Mar 05, 2018 7:18 am

It would have to be some pretty serious pitting to make it dangerous. All I can suggest is make sure you get a longer one you can cut and thread to the proper length.

PuppyWing · Post by **PuppyWing** » Thu Mar 08, 2018 7:22 pm

Here's the pushrod. What do you think?

Hoosier Jack · Post by **Hoosier Jack** » Fri Mar 09, 2018 10:48 pm

I would take a wire wheel and clean it up real good. I think it will be ok.

PuppyWing · Post by **PuppyWing** » Sat Mar 10, 2018 1:00 am

Sure but what's underneath the pitting? How far down does it go?

Compatible rear master cylinder push rods

Compatible rear master cylinder push rods

Re: Compatible rear master cylinder push rods

Re: Compatible rear master cylinder push rods

Re: Compatible rear master cylinder push rods

Re: Compatible rear master cylinder push rods