I have been looking for a pulley for a year or so.
Finally met up with Melvin who was having a pulley made for a very reasonable price.
I contacted the machinist Greg who was doing the work.
He made Melvin a pulley for a v-belt and mine with a serpentine belt.
Greg said he can punch the pulley out in short time as he has his CNC Machine programmed for the pulley's.
They are made out of aluminium and 4" wide. Very tight fit on the motor.
If you would like to purchase one or two send me a PM and I'll get you the info to order one.
He has the pulley for the 1100 and 1200. The 1000 has a different bolt hole thru the pulley.
Do U need a 4" PULLEY for conversion?
- quasi2008
- Posts: 149
- Joined: Fri Oct 05, 2018 12:18 pm
- Location: morgantown wv
- Motorcycle: 1982 GL1100I INTERSTATE
Re: Do U need a 4" PULLEY for conversion?
It was a perfect fit to the crank. spins true. no vibes. well worth it.
man can't live on air alone!
- newday777
- Posts: 2309
- Joined: Tue Jan 11, 2011 5:21 pm
- Location: Milford NH summer/fall & Oceanside, CA winters(N San Diego) with lots of miles riden between
- Motorcycle: 2008 Cabernet Red. Level 4
1983 GL1100A Wineberry 36,000 miles
1975 CB750 K5 Planet Blue 7,800 miles
1976 CB750 K6 Anterris Red 25,000 miles
Past rides
1999A Restored from PO neglect & sold at 19,000 miles
1999SE Totaled by cager at 105,000 miles
Re: Do U need a 4" PULLEY for conversion?
How much?
Wilcoy02 wrote: ↑Mon Feb 18, 2019 7:47 pm I have been looking for a pulley for a year or so.
Finally met up with Melvin who was having a pulley made for a very reasonable price.
I contacted the machinist Greg who was doing the work.
He made Melvin a pulley for a v-belt and mine with a serpentine belt.
Greg said he can punch the pulley out in short time as he has his CNC Machine programmed for the pulley's.
They are made out of aluminium and 4" wide. Very tight fit on the motor.
If you would like to purchase one or two send me a PM and I'll get you the info to order one.
He has the pulley for the 1100 and 1200. The 1000 has a different bolt hole thru the pulley.
pulley 001.JPG
pulley 002.JPG
pulley 003.JPG
- Wilcoy02
- Posts: 1212
- Joined: Sun Nov 21, 2010 11:37 pm
- Location: Marengo, Ohio
- Motorcycle: 1983 GL1100 I purchased 3/16
1983 GL1100I frame with an 80 engine. poor boy installed with C-5 ignition--DIED in Grande Prairie Alberta Canada 8/15
98 valkyrie sold 8/16
Re: Do U need a 4" PULLEY for conversion?
Greg, the machinist, told me I could post the pulley was available but he will give a price. I do not feel his phone number should be posted on a forum as he did not give me permission to do that.
PM me for that info if interested.
PM me for that info if interested.