Rear wheel off center and rubbing

[macd20]

[hello from Canada.
I have looked. They cannot seem to find an answer for this. I have a 1981 GL1100. The guy I got it from I believe put the rear wheels from an 83 onto this bike. The tires are the proper size 130s. But it seems to be rubbing on the right side. I don't know if he's changed something else, example, the drive to make it narrower that it has set the wheel off a bit. If anyone has any ideas it'd be much appreciated. I'm kind of stumped. Thank you in advance

[Rambozo]

Make sure the axle spacer stack is correct. There are a few washers, caliper bracket, and spacer collars and folks have been known to not get them back together properly.

[macd20]

Thank you very much. I've got a book. I will pull it apart and make sure everything is in there in the proper spot. The width of the wheel, is it different or would the center be a different depth?

[biguns]

I didnt know you could swap , II thought the 83 were too wide for the swingarm

[macd20]

The tire is the right size. And it fits on the rim. It's supposed to be a 130. And the 83 is 140. I do not know if the rims are offset a little or what the deal is. I've got a bunch of parts coming from a 81. I will have a look and see what I can figure out or see if it's been put together wrong and keep everybody up to date

[JoBoy68]

There is some adjustment to the swing arm remove the plastic caps and then you can loosen one side tighten the other side and it will move the swing arm