85 goldwing aspencade

[SrStoney]

I have no headlights turn signals no dash lcd with key on all fuses are new where do I need to look

[virgilmobile]

Operate the ignition switch..Wiggle,jiggle and move around several times...It's not uncommon that the switch may have bad contacts.

[SrStoney]

Ok I’ll give that a try

[SrStoney]

It also turns over but no fire

[SrStoney]

Ok I replaced switch fuses same issue any ideas

[virgilmobile]

I looked at the schematic..the black wire that comes from the ignition switch does feed the start button so it can crank the bike.The black wire also feeds the fuses through a plug.Its possible then to crank the bike but not have power to the lights if power is lost at the plug.
With a test light or meter,turn on the key and probe the fuses.See if there is volts there.If none,suspect the plug where the fuse block is plugged into.

[oldishwinger]

check for burnt wiring around the starter solenoid

[SrStoney]

Found a broken ground repaired it bike is running again. Thx for input and ideas

[virgilmobile]

Where was this broken ground?

[SrStoney]

Under the seat fuel pump wiring