Inlet manifold bolt.

Psycheonabike · Post by **Psycheonabike** » Wed Apr 03, 2019 2:46 pm

Hi...

I want ro remove the carbs to clean them. But one of the front right inlet manifold bolts is sheared. Fortunately it sheared mid way so is still holding the inlet pipe tight. Is there a way of removing the carbs by loosening the inlet rubber band insulator rather than the manifold?

Thanks...

rrod1393 · Post by **rrod1393** » Wed Apr 03, 2019 6:49 pm

Sure. I pulled my carbs out through the left side of the bike. You should be fine leaving the manifold there.

Psycheonabike · Post by **Psycheonabike** » Thu Apr 04, 2019 12:41 am

rrod1393 wrote: ↑Wed Apr 03, 2019 6:49 pm Sure. I pulled my carbs out through the left side of the bike. You should be fine leaving the manifold there.

Thanks....just wasn't sure!

Inlet manifold bolt.

Inlet manifold bolt.

Re: Inlet manifold bolt.

Re: Inlet manifold bolt.