New mofset R/R wire question

[westy57]

GL1200 1986 Aspencade SEI. Just received my new upgraded R/R from reg/ret it is the mofset .My connectors were melted and the shindengensh574a has 8 wires 3 yellow , 2 green , 2 red w/white stripe and 1 black w/white stripe (8) wires total. My mofset has ( 7 wires) 3 yellow,2 red ,2 black. I assume the 2 black go to the 2 green but what about the black sensing wire. Is it better to soder direct or should I crimp female connectors and waterproof?

[Rednaxs60]

Picture of the new RR would be nice.

[Rambozo]

The black/white is the sense wire. The new R/R does it's sensing over the main red wires, so it doesn't require a separate sense wire. Just make sure all the connections are good. It's best to solder the three yellow ones at least.

[westy57]

TY I solder them all. Looks like previous owner hooked the 2 green together down in the harness.Is this ok?

[Rednaxs60]

The original OEM wiring has the two RR green wires joined together in the wiring harness as well as the two red/white wires. You'll notice there is only one red white wire at the starter solenoid.

[westy57]

Thank you ! So many gosh darn wires on this thing!