While changing my air filter, I noticed the rubber fitting on top of radiator fill tank has a rip in rubber. A hose connects to it and goes to radiator cap, believe it's the overflow. Is there a replacement for it or can it be super glued together?
Also where can I get a rebuild kit for the fuel accelerator pump and gas cap with hose?
rubber fitting on top of radiator plastic tank
-
newday777
- Posts: 2360
- Joined: Tue Jan 11, 2011 5:21 pm
- Location: Milford NH summer/fall & Oceanside, CA winters(N San Diego) with lots of miles riden between
- Motorcycle: 2008 Cabernet Red. Level 4
1983 GL1100A Wineberry 36,000 miles
1975 CB750 K5 Planet Blue 7,800 miles
1976 CB750 K6 Anterris Red 25,000 miles
Past rides
1999A Restored from PO neglect & sold at 19,000 miles
1999SE Totaled by cager at 105,000 miles
Re: rubber fitting on top of radiator plastic tank
For what bike are you working on????
-
julimike54
- Posts: 670
- Joined: Sun Feb 01, 2015 12:21 pm
- Location: Euless, Texas
- Motorcycle: 1986 GL1200A original owner
2016 HD FLTRU
Re: rubber fitting on top of radiator plastic tank
Not sure which piece you're looking for, look at this parts diagram and see if it's available....
https://www.hondapartshouse.com/oempart ... serve-tank
https://www.hondapartshouse.com/oempart ... serve-tank
Riding anything is a good day!
Mike
-
shockdo
- Posts: 10
- Joined: Sat May 26, 2012 5:27 pm
- Location: Mattoon, Illinois
- Motorcycle: 1984 GL1200 goldwing interstate
Re: rubber fitting on top of radiator plastic tank
It's the rubber piece on top radiator reserve tank that has a plastic fitting and hose attached. For right now I've put super glue around it. This is on a 89 GL1500, just bought it.