Good evening,
I have an 86 gl1200A. I just reinstalled my clutch with new plates, however am not 100% sure I seated the clutch pack into the basket all the way. The pictures I’ve attached show how much of the clutch protrudes. Should that be flush with the basket? It took a few smacks with rubber mallet to seat it but am not sure if I’m binding on something. I test fit the rear case and turned the alternator shaft to see if anything was interfering but I didn’t hear anything. Thoughts on this, wish I took a picture prior to disassembly.
Thanks!
Clutch basket
-
Bike...and Dennis
- Posts: 234
- Joined: Sat Oct 06, 2018 2:33 pm
- Location: Glendale, Arizona
- Motorcycle: 1987 GL1200I
Re: Clutch basket
I think it's supposed to be a little proud.
-
Rob H
- Posts: 307
- Joined: Sat Dec 13, 2014 7:41 am
- Location: Muscat Oman
- Motorcycle: CBR 600, Z1000 Eddie Lawson. CBR 1000RR, Goldwing 1200 Interstate.
Re: Clutch basket
viewtopic.php?f=12&p=420180#p420180
I copied a post from a member that did the same job. Hope this helps, there are some pictures of the assembly.
I copied a post from a member that did the same job. Hope this helps, there are some pictures of the assembly.