GL1500 keyless ignition switch and bank angle sensor

[PiotrGL1500]

I'm about removing ignition switch (I already bore the bolts and all removed) and use RFID wireless sensor that works up to 2m. So the idea is to conect wires (that is why I do need wire schema of ignition switch and suggestions) to ON position and secure with RFID device https://www.aliexpress.com/item/RFID-ca ... 4c4dfGr8OH
Now I trying to figure out how to connect the wires to have hard connected ignition switch? Someone did it before?

Another question is about bank angle sensor, how to wire arround that sensor, just want to remove it from my bike? I know that is security reason and safety but anyway for now that is what I'm going to do, so if someone culd "throw me a light" how to wire arround..

[Erdeniz Umman]

You can download the wiring diagrams in the following link.
Especially, if your bike is an European model, you can use the EuroSpec diagram that I have added in the PDF file.
https://www.goldwingfacts.com/forums/2- ... agram.html

[PiotrGL1500]

Thanks for info. Great diagrams, lot of good work!!!! Do you have that diagrams in high res maybe?? I'd like to print them on A3 format that will be readable.

[bellboy40]

Here is how you can bypass that BAS.

[Erdeniz Umman]

Thanks for info. Great diagrams, lot of good work!!!! Do you have that diagrams in high res maybe?? I'd like to print them on A3 format that will be readable.

They are all in high resolution, check your computer.

[PiotrGL1500]

Thanks bellboy40. Will do this "surgery" soon. So far have plenty of work because I do rewire some harnes to get rid of inwanted stuff.
ERDENIZ, tahnks a lot again for this wiring diagrams, that will simpify my work. I have plenty of ideas but lack time. I have also few other bikes in my stable.

[AZgl1800]

Thanks for info. Great diagrams, lot of good work!!!! Do you have that diagrams in high res maybe?? I'd like to print them on A3 format that will be readable.

They are all in high resolution, check your computer.

oh yes, they are....

I zoomed in down to just a wire or two, and was amazed at how much detail you retained on those schematics.

[bellboy40]

Yes, those are some beautiful hi-res color diagrams. Looks like a lot of work went into making those. Thanks again Erdeniz.

[DougEFresh1123]

You can download the wiring diagrams in the following link.
Especially, if your bike is an European model, you can use the EuroSpec diagram that I have added in the PDF file.
https://www.goldwingfacts.com/forums/2- ... agram.html

Thank you for taking the time to create these wiring diagrams! I will be putting these to good use.

[PiotrGL1500]

Little progress in striping down my GL1500, just throw away air injection system, now will pull carbs. The biggest problem is wiring loom because I need to route it somewhere close to air box not surrounding front of handlebar.