Page 1 of 1

Pin-out for clock connector GL1500A

Posted: Tue Jun 04, 2019 12:11 pm
by CaptKen
My G1500a trike has lost ability to hold time after engine shutdown. Key sw on and the clock works fine, just has to be reset. Does any one know where I can find a pin diagram of the display module connector?

Re: Pin-out for clock connector GL1500A

Posted: Tue Jun 04, 2019 12:55 pm
by LSlinger
If you get an answer to this I'd like to know what it is, because every time I start my bike it's always 2:30. I can set the current time and as long as the key is turned on the clock works just fine but as soon as you turn off the key and turn the key back on it 2:30 again. Just like Ground Hogs Day!

Re: Pin-out for clock connector GL1500A

Posted: Tue Jun 04, 2019 1:33 pm
by MikeB
Read through this post. There is a fuse you need to check.
viewtopic.php?f=6&t=47977