Anyone have a pic to clarify? I should have taken a few upon disassembly.
Handlebar cable routing/ 2000 GL1500
-
erkmann
- Posts: 24
- Joined: Wed Aug 20, 2014 10:46 pm
- Location: St. Louis, MO
- Motorcycle: 1999 GL1500 Aspencade
1997 GL1500 SE
Handlebar cable routing/ 2000 GL1500
I have these two brackets remaining as I finish up replacing steering head bearings. Both for use in securing cables at handlebar. Smaller one likely for clutch cable but not clear how attached. Likewise with the larger one.
Anyone have a pic to clarify? I should have taken a few upon disassembly.
Anyone have a pic to clarify? I should have taken a few upon disassembly.
-
newday777
- Posts: 1768
- Joined: Tue Jan 11, 2011 5:21 pm
- Location: Milford NH summer/fall & Oceanside, CA winters(N San Diego) with lots of miles riden between
- Motorcycle: 2008 Cabernet Red. Level 4
1983 GL1100A Wineberry 36,000 miles
1975 CB750 K5 Planet Blue 7,800 miles
1976 CB750 K6 Anterris Red 25,000 miles
Past rides
1999A Restored from PO neglect & sold at 19,000 miles
1999SE Totaled by cager at 105,000 miles
Re: Handlebar cable routing/ 2000 GL1500
The large clips over and under the handle bars.
Isn't the small is for the throttle cables?
It's been 9 years since I worked of the 1500 so my rememberer is dusty....
Isn't the small is for the throttle cables?
It's been 9 years since I worked of the 1500 so my rememberer is dusty....
- Attachments
-
erkmann
- Posts: 24
- Joined: Wed Aug 20, 2014 10:46 pm
- Location: St. Louis, MO
- Motorcycle: 1999 GL1500 Aspencade
1997 GL1500 SE
Re: Handlebar cable routing/ 2000 GL1500
Thanks newday77. Small clip ends up being the one that retains the speedometer cable on the left strut down near the rotor cover. The larger one ends up clipping over the ignition key stock to retain some of the wires up there. Thanks for your reply.