Saddlebag seal, aftermarket replacement?

[FM-USA]

Now that OEM seals for the saddlebags are nonexistent has anyone found a suitable aftermarket replacement?
I've done the GOOGLE pictures rubber & foam seal profile search but they're either too small or way to big but in all basics they don't seem to be the right shape.


.

.

[CrystalPistol]

You could mask around the lip's groove inside & out using painter's tape, then "paint" the lid's lip with release agent, then fill the groove with silicone or rubber sealant, put lid on, and let it sit set a few days, then pull lid and remove release agent & tape & excess sealant. Custom molded. I've used release agent glass beading rifle stocks.

You might practice on some other object or cheap glass wear like bowl with lid, etc.

[FM-USA]

I did try three different silicones all set too stiff.
I'm currently looking at a foam tube with a single spike.

I might give this a try, just bridge over the slot.

[Erdeniz Umman]

If you are looking for #42 and #45 in the following picture, you could order them from partzilla. Note that they are for the right side.

https://www.partzilla.com/catalog/honda ... /saddlebag

[FM-USA]

Yup, looked there first and checked other years.
46 BAG, SADDLEBAG (INNER) 81365-MAM-A80 Unavailable

[Erdeniz Umman]

Also, for the left side, if you search with part number, you may find it on eBay.

[Erdeniz Umman]

Yup, looked there first and checked other years.
46 BAG, SADDLEBAG (INNER) 81365-MAM-A80 Unavailable

It is the bag inside. Check again.

[FM-USA]

OOOooohhhh, I didn't see the STACK of numbers.
Will look into it.
THANKS!

[Erdeniz Umman]

Also, if you search using the part number you may find the right side rubber on eBay and some other online shops as well.