I have a 2009 Goldwing , that the turn signal don't work when you put switch on left or right, the emergy light flashes.
has anyone run into this problem.
2009 goldwing turn and emerg. lights
-
- Posts: 1056
- Joined: Wed Nov 30, 2011 4:17 pm
- Location: Hermansville, Mich
- Motorcycle: 1990 Gold wing Trike
- Contact:
Re: 2009 goldwing turn and emerg. lights
1st, check the fuse, 2nd, trade flashers, 3rd, check grounds(which is what you are describing).
Proud member Patriot Guard
-
- Posts: 7
- Joined: Tue Aug 17, 2010 10:14 pm
- Location: Jackson, Mississippi
- Motorcycle: 1996 GL1500 SE
1982GL1100 Aspencade
Re: 2009 goldwing turn and emerg. lights
I have already checked relays, fuse, wiring, diodes, couldn't find any thing wrong.
- seelyark1
- Posts: 657
- Joined: Sun May 27, 2012 1:57 pm
- Location: Dunnellon, Florida
- Motorcycle: 2000 GL1500 SE
1998 GL1500 SE Totaled
1984 VT500C
1967 CB550-4
Re: 2009 goldwing turn and emerg. lights
All well and good, but did you check the grounds like Bustedwing suggested? I agree with him as to that being your problem. Lights will "hunt" for a ground and no telling where they will find it.
Ride safe, and smart. Asphalt is like #1 grit sandpaper. Dave
-
- Posts: 7
- Joined: Tue Aug 17, 2010 10:14 pm
- Location: Jackson, Mississippi
- Motorcycle: 1996 GL1500 SE
1982GL1100 Aspencade
Re: 2009 goldwing turn and emerg. lights
The grounds is what I thought, first thing I checked
- WOJCIECH
- Posts: 151
- Joined: Sun Feb 28, 2010 5:39 am
- Location: Pabianice Poland
- Motorcycle: GL 1800 2009
GL 1800 2009 trike Redwing
Re: 2009 goldwing turn and emerg. lights
Have you checked turn signal cancel unit and the relay under the glass ?
- zalesjak
- Posts: 13
- Joined: Sun Jul 15, 2012 8:35 am
- Location: Branik, Slovenia
- Motorcycle: 2007 GL1800 Goldwing, Airbag
Re: 2009 goldwing turn and emerg. lights
I had the same issue one year ago.
The problem was some bad contact on the connector on the canceling unit under dashboard (the smalest of the thre).
I disconected connector, spray the connector with WD40 and reconnect the cable back.
Turn signals work perfect.
Ride save.
The problem was some bad contact on the connector on the canceling unit under dashboard (the smalest of the thre).
I disconected connector, spray the connector with WD40 and reconnect the cable back.
Turn signals work perfect.
Ride save.
-
- Posts: 7
- Joined: Tue Aug 17, 2010 10:14 pm
- Location: Jackson, Mississippi
- Motorcycle: 1996 GL1500 SE
1982GL1100 Aspencade
Re: 2009 goldwing turn and emerg. lights
I haven't figured out how to get to the canceling unit. not sure on how to remove dashboard to get to it.
- WOJCIECH
- Posts: 151
- Joined: Sun Feb 28, 2010 5:39 am
- Location: Pabianice Poland
- Motorcycle: GL 1800 2009
GL 1800 2009 trike Redwing
Re: 2009 goldwing turn and emerg. lights
switch is in the rudder steering tube, remove the front speakers, remove the plastic on the top shelf, the rubber is a green cube, a small 7 pin
http://www.hondadirectline.com/OEMpartf ... MCAAF0900A
NR 1
http://www.hondadirectline.com/OEMpartf ... MCAAF0900A
NR 1