Fishing wire...


Information and questions on GL1800 Goldwings (2001-2017)
Post Reply
tj5iveo
Posts: 35
Joined: Sun Mar 21, 2010 5:31 pm
Location: Poland, Ohio
Motorcycle: 2016 GL1800

Fishing wire...

Post by tj5iveo »



New 2016 GL1800 audio/comfort. '06 had a nice Honda volt meter from Electrical Connection mounted on throttle side below the cubby next to key. Obviously with the controld on the '16 under that cubby, most say that that volt meter cannot be installed. So i found digital volt meter, round, and i think like 1" deep so i am thinking this will fit. only need to drill the hole as it comes with a plastic nut to secure. I also know there is no power connection on the throttle side like the '06. Any easy way to fish a wire from the clutch side to the throttle side to supply power? I have some 36" plastic wire ties i use to fish wires as well as the 1/8" fiberglass screw together pieces. I am hoping a simple route around the front inside of the fairing??? Any "directions"???
PS i did remove the dash and install a small red LED tom the inside of the clutch side speaker which is kinda cool but i like the round one...
Happy riding finally if u r in NE Ohio...
Tom



Post Reply