Broken wire in remote lock harness
-
vothger
- Posts: 15
- Joined: Tue Jul 28, 2015 8:39 pm
- Location: swift current,s,can
- Motorcycle: 1997 gl1500a aspencade, totaled by a deer
2002 gl1800abs
Broken wire in remote lock harness
My remote lock and unlock for the truck and saddlebags was not working. I checked it out and found a broken wire in the harness by the trunk hinges. I seem to recall reading about rerouting the harness to prevent this from reoccurring but can not find this info. Has any body relocated the controll unit to another location other than the trunk lid to eliminate the wire bending ever time the trunk is opened?
-
vothger
- Posts: 15
- Joined: Tue Jul 28, 2015 8:39 pm
- Location: swift current,s,can
- Motorcycle: 1997 gl1500a aspencade, totaled by a deer
2002 gl1800abs
Re: Broken wire in remote lock harness
Sorry forgot to say this is a 2002 gl 1800
-
newday777
- Posts: 2341
- Joined: Tue Jan 11, 2011 5:21 pm
- Location: Milford NH summer/fall & Oceanside, CA winters(N San Diego) with lots of miles riden between
- Motorcycle: 2008 Cabernet Red. Level 4
1983 GL1100A Wineberry 36,000 miles
1975 CB750 K5 Planet Blue 7,800 miles
1976 CB750 K6 Anterris Red 25,000 miles
Past rides
1999A Restored from PO neglect & sold at 19,000 miles
1999SE Totaled by cager at 105,000 miles
Re: Broken wire in remote lock harness
Just move the wires behind the backrest and seat bolster.
-
GoldWingrGreg
- Posts: 1192
- Joined: Tue Aug 24, 2010 7:18 am
- Location: Zephyrhills, Florida
- Motorcycle: 89 GL1500
03 GL1800
04 GL1800(abs)
05 GL1800(abs)
07 GL1800(abs) - Contact:
Re: Broken wire in remote lock harness
Sorry ... I didn't reply because you were asking for a repair other then what I would recommend. Basically your harness needs replaced, and it should be routed as the original one. If it is still available, it is part #9.vothger wrote: ↑Fri Nov 20, 2020 11:06 am My remote lock and unlock for the truck and saddlebags was not working. I checked it out and found a broken wire in the harness by the trunk hinges. I seem to recall reading about rerouting the harness to prevent this from reoccurring but can not find this info. Has any body relocated the controll unit to another location other than the trunk lid to eliminate the wire bending ever time the trunk is opened?
https://www.mrcycles.com/oemparts/a/hon ... re-harness