Air Temperature Sensor showing dashed lines

[alanm61]

Hello everyone, thanks so much for letting us join. We have a 2016 Goldwing with a CSC Viper kit. We bought it in 2019 and had it triked. The temp sensor has been working fine up until I changed the headlights from the old bulbs to the new Pathfinder LED bulbs. I guess its possible that I have unplugged/crimped the sensor wire while trying to get the high beams installed. Not much room to get to those bulbs and I went in from under the fairing, above the the front wheel. It was mostly feel my way since you can't really see up in there with my big hand. The problem is I'm not exactly sure where the sensor is. I know its somewhere on the right side below the speaker and above and to the right of the high beam.
I removed the windshield again this evening and released the dash and pushed it back. I also removed the right air ride adjust panel where the radiator cap is. I just can't seem to get my hands in there to see if there is a wire loose, nor can I see where the sensor actually is. One other note, I also installed a new set of fog/driving lights in the lower cowl. Those wires plugged into the turn signals wiring behind the mirrors, but I can't seem to see where I have unplugged anything....Any help would be greatly appreciated. Thanks so much.

[Rambozo]

It is located in the right air duct.

[alanm61]

Thank you, I will keep looking tomorrow. From your picture I see that I'm looking for a white two prong connector which helps alot.

[alanm61]

Thanks everyone for the info, I was able to find the sensor and got it re-connected.