need a few parts for my newly aquired 82 gl1100i

quasi2008 · Post by **quasi2008** » Sun Oct 07, 2018 6:32 pm

on the hunt for a rear caliper w/bolts. a seat adjustment bolt. a rear master cylinder in rebuildable shape. tks

Wilcoy02 · Post by **Wilcoy02** » Mon Oct 08, 2018 11:56 am

The seat bolt-- I have not used mine in over 10 years. The seat is not going any where so I don't use the bolt.
Same with the 2 front bolts that hold the false tank on.

quasi2008 · Post by **quasi2008** » Wed Oct 10, 2018 6:55 pm

found all I needed, tks

quasi2008 · Post by **quasi2008** » Sun Oct 14, 2018 3:17 pm

got a caliper for the bike, needed the rear caliper. the one I have appears to be for the left front. mounts up ok. however the mounting bolt bushings and boots for the pivot bolt are gone.

TerryRuth · Post by **TerryRuth** » Tue Oct 16, 2018 11:41 am

well if the rear master cylinder is only 1/2 the job that a 95 1500 is I would NOT EVER replace it with ANYTHING but BRAND BRAND new It's not a job you want to do TWICE trust me ! ! !

TerryRuth · Post by **TerryRuth** » Tue Oct 16, 2018 11:47 am

and I junked 1 IDENTICAL in Edmonton it's at Vicious cycle had carb issues
new owers 82 1100 grey

quasi2008 · Post by **quasi2008** » Tue Oct 16, 2018 2:55 pm

rear master cylinder came right apart after I put a little heat from a map torch to it. not to difficult to remove.

need a few parts for my newly aquired 82 gl1100i

need a few parts for my newly aquired 82 gl1100i

Re: need a few parts for my newly aquired 82 gl1100i

Re: need a few parts for my newly aquired 82 gl1100i

Re: need a few parts for my newly aquired 82 gl1100i

Re: need a few parts for my newly aquired 82 gl1100i

Re: need a few parts for my newly aquired 82 gl1100i

Re: need a few parts for my newly aquired 82 gl1100i