Rubber tab


Information and questions on GL1500 Goldwings (1988-2000)
  • Sponsored Links
Post Reply
tcryder
Posts: 78
Joined: Fri Nov 27, 2015 8:19 am
Location: Bentonville, Arkansas
Motorcycle: 1994 GL1500A Aspencade with 2006 Motor Trike conversion.

Rubber tab

Post by tcryder » Thu Aug 09, 2018 8:11 am



While removing the radio cassette cover a small I believe plastic or rubber bushing that fits on the left and right body of the radio cover I lost while changing my fuel filter. They are about inch wide black and they slide on the covers and the radio cover fits on top of that. Does anyone know where I could get that tab? Thank you t c r y d e r



User avatar
virgilmobile
Posts: 8493
Joined: Sun Sep 19, 2010 5:39 pm
Location: Denham Springs,La.
Motorcycle: 1988 GL1500 I
Previously owned
78 GL1000
81 GL1100
82 GL1100 I
83 GL1100 I
83 GL1100 standard
84 GL 1200 I

Re: Rubber tab

Post by virgilmobile » Thu Aug 09, 2018 8:36 am

Till you find one ...you can cut a inch length of fuzzy side Velcro and put it in the same place.

User avatar
virgilmobile
Posts: 8493
Joined: Sun Sep 19, 2010 5:39 pm
Location: Denham Springs,La.
Motorcycle: 1988 GL1500 I
Previously owned
78 GL1000
81 GL1100
82 GL1100 I
83 GL1100 I
83 GL1100 standard
84 GL 1200 I

Re: Rubber tab

Post by virgilmobile » Thu Aug 09, 2018 8:40 am

As a matter of fact...I use small fuzzy Velcro pieces all over the bike...Like the inside lip of the trunk lid...Side covers..etc...You can see where the two parts rub and squeak or rattle.

tcryder
Posts: 78
Joined: Fri Nov 27, 2015 8:19 am
Location: Bentonville, Arkansas
Motorcycle: 1994 GL1500A Aspencade with 2006 Motor Trike conversion.

Re: Rubber tab

Post by tcryder » Thu Aug 09, 2018 10:19 am

Thanks for the input. tcryder

User avatar
virgilmobile
Posts: 8493
Joined: Sun Sep 19, 2010 5:39 pm
Location: Denham Springs,La.
Motorcycle: 1988 GL1500 I
Previously owned
78 GL1000
81 GL1100
82 GL1100 I
83 GL1100 I
83 GL1100 standard
84 GL 1200 I

Re: Rubber tab

Post by virgilmobile » Thu Aug 09, 2018 10:41 am

I suppose if you can't find OEM ones,you could slice the side open a small rubber hose and cut to length.



Post Reply