WTB lift table


Motorcycle related items for sale or wanted
  • Sponsored Links
Post Reply
Bill P.
Posts: 7
Joined: Thu Aug 16, 2018 5:58 pm
Location: Bradley Beach, NJ
Motorcycle: 1980 GL1100 Interstate
1976 Suzuki GT550

WTB lift table

Post by Bill P. » Sun Oct 21, 2018 7:46 pm



Looking for a 1500 lb capacity lift table. Used would be good, I'm on a budget.



User avatar
Wilcoy02
Posts: 956
Joined: Sun Nov 21, 2010 11:37 pm
Location: Marengo, Ohio
Motorcycle: 1983 GL1100 I purchased 3/16

1983 GL1100I frame with an 80 engine. poor boy installed with C-5 ignition--DIED in Grande Prairie Alberta Canada 8/15


98 valkyrie sold 8/16

Re: WTB lift table

Post by Wilcoy02 » Wed Oct 24, 2018 5:38 pm

go to Harbor Freight with a 20% off coupon.

Bill P.
Posts: 7
Joined: Thu Aug 16, 2018 5:58 pm
Location: Bradley Beach, NJ
Motorcycle: 1980 GL1100 Interstate
1976 Suzuki GT550

Re: WTB lift table

Post by Bill P. » Thu Oct 25, 2018 11:53 am

Yeah, I looked at that Harbor Freight table. Too many bad reviews on hydraulic leaks and other assorted problems. I can probably get away with a 1,000 lb table, but a new one just isn't in my budget. If I can't find a used one I'm going to repair and reinforce my homemade table.

tomk1960
Posts: 16
Joined: Thu Sep 27, 2018 8:19 am
Location: Worcester, MA
Motorcycle: 2010 Kawasaki Nomad, 1986 Honda VFR750F, 1983 CB1100F Super Sport, (3) 1978 Honda GL1000, 1974 CB750 Four

Re: WTB lift table

Post by tomk1960 » Thu Oct 25, 2018 12:44 pm

I've used my HF table for the past 7 years with no issues. No hydraulic leaks and no mishaps. There are two things that must be done immediately after you purchase: 1) check the fluid level in the jack and top it off, because it's usually quite low. 2) spend the money on a good front wheel vise. The one from HF is flimsy and useless.

I have no idea if the ones HF is selling now are the same or more cheaply made than mine, but I wouldn't hesitate to recommend this to anyone. It's been a real back saver for me.

User avatar
Wilcoy02
Posts: 956
Joined: Sun Nov 21, 2010 11:37 pm
Location: Marengo, Ohio
Motorcycle: 1983 GL1100 I purchased 3/16

1983 GL1100I frame with an 80 engine. poor boy installed with C-5 ignition--DIED in Grande Prairie Alberta Canada 8/15


98 valkyrie sold 8/16

Re: WTB lift table

Post by Wilcoy02 » Thu Oct 25, 2018 1:09 pm

I have had my HF table for about a year.
Yes fill the bottle jack up with fluid.
I have had no problems with mine either. I would recommend it to others. The front tire chock is good and holds the front wheel in place.
I made some foot boards so I can ride the bike up and not fall over.



Post Reply