2014 no start issue- resolved


Information and questions on GL1800 Goldwings (2001-2017)
Post Reply
draggin14
Posts: 2
Joined: Tue Sep 09, 2014 8:21 pm
Location: Pennsylvania
Motorcycle: 2014 GL1800

2014 no start issue- resolved

Post by draggin14 » Mon Jul 01, 2019 10:31 pm



A week or so ago, I was taking the 2014 bike out to gas it up in preparation for a trip to Maggie Valley. I geared up and pressed the start button and it just spun over. No start! I tried again and the Fault Indicator light came on. I searched the web and found out how to ID the codes. I have less than 20k on the wing and didn't want to believe that I had a gremlin like this. It was a code 19. I then saw a thread somewhere that said to hold the throttle wide open and crank it. I tried it and it fired up after cranking for a short time! I was fearful of a repeat for the entire 1500 mile trip (wed - Fri) but I had no issues after that. It had been sitting for about a week before this. I am just hoping that it doesn't become an issue going forward.
B



User avatar
GoldWingrGreg
Posts: 499
Joined: Tue Aug 24, 2010 7:18 am
Location: Zephyrhills, Florida
Motorcycle: 89 GL1500
03 GL1800
04 GL1800(abs)
05 GL1800(abs)
07 GL1800(abs)
Contact:

Re: 2014 no start issue- resolved

Post by GoldWingrGreg » Tue Jul 02, 2019 9:16 am

Correct me if I am wrong, but I believe code 19 is the crank position sensor. Those are known to be intermittent when failing. Hopefully, intermittent failure will not happen on your trip. As time passes, intermittent will become more consistent.

User avatar
Sempai
Posts: 310
Joined: Wed Mar 10, 2010 12:30 am
Location: Wichita, KS
Motorcycle: '94 GL1500SE
'14 GL1800F6B
Contact:

Re: 2014 no start issue- resolved

Post by Sempai » Tue Jul 09, 2019 10:21 am

I had the exact issue with my ‘14 F6B. Randomly didn’t want to start. Turned out to be a CPS going bad. Replace it.
Keep the rubber side down.

Mecurbster
Posts: 1
Joined: Wed Sep 30, 2015 9:54 am
Location: Shawnee, Kansas
Motorcycle: 2014 Goldwing GL1800A
2004 Harley Davidson Road King Classic

Re: 2014 no start issue- resolved

Post by Mecurbster » Sat Jul 20, 2019 8:55 pm

Had the same, crank postion sesnsor went bad on my '14 at 47,000. Hesitated to start twice, weeks apart, before finally giving up. Fault code was correct. Luckily still under warranty,$$$.



Post Reply