GL1200 LTD Garage find - Timing Belt etc.


Information and questions on GL1200 Goldwings (1984-1987)
Post Reply
Baggerr
Posts: 1
Joined: Mon Nov 03, 2014 3:38 pm
Location: Richmond, VA
Motorcycle: 2012 GL1800
1985 GL1200 LTD
1975 CB750
1974 CB750

GL1200 LTD Garage find - Timing Belt etc.

Post by Baggerr » Wed Feb 12, 2020 7:45 pm



I have a co-worker who builds race cars and was complaining about an old motorcycle in his garage and said I could have it if I wanted it. He knows I love old Honda motorcycles. I will pick it up my new to me GL1200 LTD this weekend and was told that the bike runs just fine. Although It does have two issues. A shutoff switch that intermittently kills the bike and the self leveling rear shocks well don't self level. I believe both can be fixed or worked around. What I also want to do is replace the timing belts, change all fluids and fix the stator wires before they become a problem. Problem is I can't find anything that shows how to take the Tupperware off and can't find any info on replacing the timing belts. Does anybody know of a pdf somewhere that has the timing belt replacement step? I have searched for three days and can't seem to locate anything. Also is there other maintenance or known issues that should be taken care of right away?

Any help will be appreciated.
Mark



User avatar
Rednaxs60
Posts: 2131
Joined: Wed Nov 18, 2015 12:44 pm
Location: Victoria, British Columbia, Canada
Motorcycle: 1985 GL1200 LTD
1995 GL1500 SE CDN Edition
2012 Suzuki DL1000 VStrom
2008 GL1800 (sold)
Ontario 1985 GL1200 LTD (sold)

Re: GL1200 LTD Garage find - Timing Belt etc.

Post by Rednaxs60 » Thu Feb 13, 2020 1:10 pm

Nice find. These are great bikes when on the road. Mine is off road for maintenance and is my retirement project. Have done lots of tours, solo and two up.

First order of business is to get a copy of the OEM service manual, the electrical trouble shooting manual, and the supplement. Without these you will be guessing a lot. To take the plastic off the bottom fairings come off first, straight forward once you start.

Timing belts
Fluid changes - brake/clutch fluid (both the same Dot 4) - would recommend removing and rebuilding clutch slave cylinder, coolant
Front fork oil change
New brake pads
Rear shocks - can be rebuilt or you can install Progressive non-air shocks. If you replace with non-air Progressive shocks, the bike will sit approximately 1 inch higher and when on centre stand, rear tire will still contact the ground. The eye to eye distance on the air shocks is approximately 13 3/4 inches - the eye to eye of the Progressive non air is approximately 14 1/2 inches. Check to make sure the air compressor is working.
Change desicant in air dryer, needs to be done
Remove rear wheel and take out shaft drive, lube all splines. New final drive oil

Lots of other considerations but this is a start. Manuals first.

Good luck. Cheers
"When you write the story of your life, don't let anyone else hold the pen"

Ernest

Post Reply